Question 361: A technician has a remote site that often has congestion issues. When this happens, the remote router cannot be managed using SSH because the session drops. Which of the following is a possible solution to the issue?
A. Out-of-band management
B. HTTPS management URL
C. Client-to-site VPN
D. Router ACL
Question 362: After rebooting a PC, a user is no longer able to connect to the corporate network. As a test, the technician plugs a different laptop into the same network jack and receives an IP address of 169.254.112.137. Which of the following is MOST likely causing the issue?
A. DHCP scope exhaustion
B. Improper DNS setting
C. Incorrect ACL setting
D. Port-security violation
Question 363: A network technician travels to a remote office to set up a new SOHO for the company. Wireless networking should be used at the remote office. The network technician sets up all the related wireless network equipment, and the last step is to connect the users’ devices to the company network. To complete this step, which of the following should be used to secure the remote network location?
A. Host-based firewalls
C. Open access
D. Port filtering
Question 364: A network technician installed a new host on the network. The host is not connecting to the company’s cloud servers. The technician attempts to ping a server using the IP address with no success. Checking the IP address using ipconfing displays:
IP address: 10.10.23.231
Subnet mask: 255.255.192.0
Default Gateway: 10.10.20.1
Which of the following should the technician perform NEXT to determine where the issue is located?
A. Modify the default gateway address and ping the server to test connectivity.
B. Change the DNS servers to be on the same subnet as the host.
C. Modify the router’s ACL to allow port 80 to exit the network.
D. Perform a tracert command to locate where the packet is dropped.
Question 365: Which of the following MUST be installed on an employee’s computer if the remote access VPN implements an SSL VPN with PKI authentication?
A. Shared secret
B. HTTPS server
C. Soft token
D. Private certificate
Question 366: A user calls the help desk for assistance with setting up a new SOHO router. The user has three employees who all have laptops that need to connect to the wireless network. The users need to have firewall rules allowing access to an internal server, but cannot be configured with static IP addresses. Which of the following BEST describes what the technician should implement?
A. CNAME record in the users’ dynamic DNS accounts
B. Additional lease time for the laptop computers
C. IP helper relay system for configuration hops
D. DHCP reservation for the laptops’ MACs
Question 367: A company has just installed a new cloud VoIP solution; however, users occasionally report poor call quality or dead air being present. Which of the following describes the NEXT troubleshooting step the technician should take?
A. The technician should check the internal diagnostics on all the phones to look for a common thread.
B. The technician should reset all the phones and reprovision information from the provider
C. The technician should use a packet tracer to see if the traffic is getting out of the network
D. The technician should run ping tests on the Internet line to monitor for packet loss and latency
Question 368: A user reports network resources can no longer be accessed. The PC reports a link but will only accept static IP addresses. The technician pings other devices on the subnet, but the PC displays the message Destination unreachable. Which of the following are MOST likely the causes of this issue? (Choose two.)
A. Damaged cables
C. Bent pins
D. TX/RX reverse
E. VLAN mismatch
F. Duplex mismatch
C. Bent pins
E. VLAN mismatch
Question 369: Users have been experiencing connection timeout issues when using a web-based program. The network technician determines the problem happened due to a TTL setting that was set too low on the firewall. Which of the following BEST enabled the network technician to reach this conclusion?
A. Reviewing application logs
B. Reviewing a baseline report
C. Reviewing a vulnerability scan
D. Reviewing SLA requirements
Question 370: A new technician is connecting an access switch to a distribution switch uplink in a datacenter using fiber cables. Which of the following are transceivers the technician should use to perform this job? (Choose two.)