Skip to Content

Huawei Certified ICT Associate HCIA Routing & Switching H12-211 Exam Questions and Answers – Page 2

The latest Huawei Certified ICT Associate HCIA Routing & Switching H12-211 actual real practice exam question and answer (Q&A) dumps are available free, which are helpful for you to pass the Huawei Certified ICT Associate HCIA Routing & Switching H12-211 exam.

Exam Question 171

As shown in the following figure, switch A and router A are connected through two links. The two links are aggregated in manual load balancing mode. The aggregation port number is 1. The aggregated link needs to carry VLAN tag 100. Switch A uses the trunk link.
Switch A and router A are connected through two links. The two links are aggregated in manual load balancing mode. The aggregation port number is 1. The aggregated link needs to carry VLAN tag 100. Switch A uses the trunk link.
Which of the following configurations need to be performed on switch A?

A. interface Eth-Trunk1
ip address 10.0.12.1 255.255.255.0
#
B. interface Eth-Trunk1
mode lacp-static
port link-type trunk
port trunk allow-pass vlan 100
#
interface GigabitEthernet0/0/1
eth-trunk 1
#
C. interface Eth-Trunk1
port link-type trunk
port trunk allow-pass vlan 100
#
interface GigabitEthernet0/0/1
eth-trunk 1
#
interface GigabitEthernet0/0/2
eth-trunk 1
#
D. interface Vlanif100
ip address 10.0.12.1 255.255.255.0
#
Correct Answer:
B. interface Eth-Trunk1
mode lacp-static
port link-type trunk
port trunk allow-pass vlan 100
#
interface GigabitEthernet0/0/1
eth-trunk 1
#

Exam Question 172

According to the following topology and configuration, R1 and R2 are connected through low-speed serial cables and PPP is used to encapsulate data link layer packets. When the Holdtime values of R1 and R2 are different, PPP negotiation and communication fail.
According to the following topology and configuration, R1 and R2 are connected through low-speed serial cables and PPP is used to encapsulate data link layer packets. When the Holdtime values of R1 and R2 are different, PPP negotiation and communication fail.

A. True
B. False
Correct Answer:
B. False

Exam Question 173

Which of the following is not included in AAA?

A. Audit
B. Authentication
C. Authorization
D. Accounting
Correct Answer:
A. Audit

Exam Question 174

Which of the following encapsulation modes are supported by IPsec VPN? (Choose two.)

A. Routing mode
B. Tunnel mode
C. Transport mode
D. Switching mode
Correct Answer:
B. Tunnel mode
C. Transport mode

Exam Question 175

The IKE protocol is used to set up an SA for IPsec automatic negotiation. Identity authentication can be performed when the IP address of the initiator changes dynamically.

A. True
B. False
Correct Answer:
A. True

Exam Question 176

Which of the following SNMP packets is sent by the agent on the managed device to the NMS?

A. Get-Request
B. Response
C. Get-Next-Request
D. Set-Request
Correct Answer:
B. Response

Exam Question 177

Which of the following statements are true according to the following command output?
Which of the following statements are true according to the following command output?

A. The OSPFv3 area ID is 0.
B. The OSPFv3 process ID is 1.
C. The DR priority of the local router is 1.
D. The router ID of the neighbor is 10.0.1.1.
Correct Answer:
A. The OSPFv3 area ID is 0.
B. The OSPFv3 process ID is 1.
C. The DR priority of the local router is 1.

Exam Question 178

Which of the following address types are of IPv6 addresses?

A. Unicast address
B. Anycast address
C. Multicast address
D. Broadcast address
Correct Answer:
A. Unicast address
B. Anycast address
C. Multicast address

Exam Question 179

In the MPLS domain, the full name of LER is label egress router.

A. True
B. False
Correct Answer:
B. False

Exam Question 180

Which area ID is used by OSPFv3 to identify the backbone area?

A. 0
B. 3
C. 2
D. 1
Correct Answer:
A. 0