The latest Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 certification actual real practice exam question and answer (Q&A) dumps are available free, which are helpful for you to pass the Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 exam and earn Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 certification.
Exam Question 71
Refer to the exhibit.
Which type of antenna does the radiation pattern represent?
A. multidirectional
B. directional patch
C. omnidirectional
D. Yagi
Correct Answer:
D. Yagi
Exam Question 72
Wireless users report frequent disconnections from the wireless network. While troubleshooting, a network engineer finds that after the user is disconnected, the connection re-establishes automatically without any input required. The engineer also notices these message logs:
AP ‘AP2’ is down. Reason: Radio channel set. 6:54:04 PM
AP ‘AP4’ is down. Reason: Radio channel set. 6:44:49 PM
AP ‘AP7’ is down. Reason: Radio channel set. 6:34:32 PM
Which action reduces the user impact?
A. enable coverage hole detection
B. increase the AP heartbeat timeout
C. enable BandSelect
D. increase the dynamic channel assignment interval
Correct Answer:
D. increase the dynamic channel assignment interval
Exam Question 73
What is the purpose of an RP in PIM?
A. send join messages toward a multicast source SPT
B. ensure the shortest path from the multicast source to the receiver
C. receive IGMP joins from multicast receivers
D. secure the communication channel between the multicast sender and receiver
Correct Answer:
A. send join messages toward a multicast source SPT
Exam Question 74
Refer to the exhibit. Which command must be applied to R2 for an OSPF neighborship to form?
A. network 20.1.1.2 255.255.0.0 area 0
B. network 20.1.1.2 0.0.0.0 area 0
C. network 20.1.1.2 255.255.255.255 area 0
D. network 20.1.1.2 0.0.255.255 area 0
Correct Answer:
B. network 20.1.1.2 0.0.0.0 area 0
Exam Question 75
Refer to the exhibit. Which router is the designated router on the segment 192.168.0.0/24?
A. This segment has no designated router because it is a p2p network type.
B. Router Chicago because it has a lower router ID.
C. Router NewYork because it has a higher router ID.
D. This segment has no designated router because it is a nonbroadcast network type.
Correct Answer:
A. This segment has no designated router because it is a p2p network type.
Exam Question 76
Refer to the exhibit. An engineer attempts to configure a router on a stick to route packets between Clients, Servers, and Printers; however, initial tests show that this configuration is not working. Which command set resolves this issue?
A. interface Vlan10
no ip vrf forwarding Clients
!
interface Vlan20
no ip vrf forwarding Servers
!
interface Vlan30
no ip vrf forwarding Printers
B. router eigrp 1
network 10.0.0.0 255.255.255.0
network 172.16.0.0 255.255.255.0
network 192.168.1.0 255.255.255.0
C. interface Vlan10
no ip vrf forwarding Clients
ip address 192.168.1.2. 255.255.255.0
!
interface Vlan20
no ip vrf forwarding Servers
ip address 172.16.1.2 255.255.255.0
!
interface Vlan30
no ip vrf forwarding Printers
ip address 10.1.1.2 255.255.255.0
D. router eigrp 1
network 10.0.0.0 255.0.0.0
network 172.16.0.0 255.255.0.0
network 192.168.1.0 255.255.0.0
Correct Answer:
C. interface Vlan10
no ip vrf forwarding Clients
ip address 192.168.1.2. 255.255.255.0
!
interface Vlan20
no ip vrf forwarding Servers
ip address 172.16.1.2 255.255.255.0
!
interface Vlan30
no ip vrf forwarding Printers
ip address 10.1.1.2 255.255.255.0
Exam Question 77
How does SSO work with HSRP to minimize network disruptions?
A. It enables HSRP to elect another switch in the group as the active HSRP switch.
B. It ensures fast failover in the case of link failure.
C. It enables data forwarding along known routes following a switchover, while the routing protocol reconverges.
D. It enables HSRP to failover to the standby RP on the same device.
Correct Answer:
C. It enables data forwarding along known routes following a switchover, while the routing protocol reconverges.
Exam Question 78
Refer to the exhibit. Which command when applied to the Atlanta router reduces type 3 LSA flooding into the backbone area and summarizes the inter-area routes on the Dallas router?
A. Atlanta(config-router)#area 0 range 192.168.0.0 255.255.252.0
B. Atlanta(config-router)#area 1 range 192.168.0.0 255.255.248.0
C. Atlanta(config-router)#area 0 range 192.168.0.0 255.255.248.0
D. Atlanta(config-router)#area 1 range 192.168.0.0 255.255.252.0
Correct Answer:
D. Atlanta(config-router)#area 1 range 192.168.0.0 255.255.252.0
Exam Question 79
An engineer must configure interface GigabitEthernet0/0 for VRRP group 10. When the router has the highest priority in the group, it must assume the master role. Which command set must be added to the initial configuration to accomplish this task?
Initial Configuration
interface GigabitEthernet0/0
description To IDF A 38-24-044.40
ip address 172.16.13.2 255.255.255.0
A. standby 10 ip 172.16.13.254 255.255.255.0
standby 10 preempt
B. vrrp group 10 ip 172.16.13.254 255.255.255.0
vrrp group 10 priority
C. standby 10 ip 172.16.13.254
standy 10 priority 120
D. vrrp 10 ip 172.16.13.254
vrrp 10 preempt
Correct Answer:
D. vrrp 10 ip 172.16.13.254
vrrp 10 preempt
Exam Question 80
Refer to the exhibit. Which two commands ensure that DSW1 becomes the root bridge for VLAN 10 and 20? (Choose two.)
A. spanning-tree mst 1 priority 4096
B. spanning-tree mst 1 root primary
C. spanning-tree mst vlan 10,20 priority root
D. spanning-tree mst 1 priority 1
E. spanning-tree mstp vlan 10,20 root primary
Correct Answer:
A. spanning-tree mst 1 priority 4096
B. spanning-tree mst 1 root primary