The latest Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 certification actual real practice exam question and answer (Q&A) dumps are available free, which are helpful for you to pass the Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 exam and earn Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 certification.
Exam Question 61
Which feature is supported by EIGRP but is not supported by OSPF?
A. route filtering
B. unequal-cost load balancing
C. route summarization
D. equal-cost load balancing
Correct Answer:
B. unequal-cost load balancing
Exam Question 62
A local router shows an EBGP neighbor in the Active state.
Which statement is true about the local router?
A. The local router is attempting to open a TCP session with the neighboring router.
B. The local router is receiving prefixes from the neighboring router and adding them in RIB-IN.
C. The local router has active prefixes in the forwarding table from the neighboring router.
D. The local router has BGP passive mode configured for the neighboring router.
Correct Answer:
A. The local router is attempting to open a TCP session with the neighboring router.
Exam Question 63
Refer to the exhibit.
An engineer must ensure that all traffic leaving AS 200 will choose Link 2 as the exit point.
Assuming that all BGP neighbor relationships have been formed and that the attributes have not been changed on any of the routers, which configuration accomplishes this task?
A. R4(config-router)bgp default local-preference 200
B. R3(config-router)bgp default local-preference 200
C. R4(config-router)neighbor 10.2.2.2 weight 200
D. R3(config-router)neighbor 10.1.1.1 weight 200
Correct Answer:
A. R4(config-router)bgp default local-preference 200
Exam Question 64
Which feature of EIGRP is not supported in OSPF?
A. load balancing of unequal-cost paths
B. load balance over four equal-cost paths
C. uses interface bandwidth to determine best path
D. per-packet load balancing over multiple paths
Correct Answer:
A. load balancing of unequal-cost paths
Exam Question 65
Refer to the exhibit.
An engineer reconfigures the port-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1’s log:
*Mar 1 09:47:22.245: %PM-4-ERR_DISABLE: bpduguard error detected on Gi0/0, putting Gi0/0 in errdisable state
Which command set resolves this error?
A. SW1(config-if)#interface Gi0/0
SW1(config-if)#no spanning-tree bpdufilter
SW1(config-if)#shut
SW1(config-if)#no shut
B. SW1(config-if)#interface Gi0/0
SW1(config-if)#no spanning-tree bpduguard enable
SW1(config-if)#shut
SW1(config-if)#no shut
C. SW1(config-if)#interface Gi0/0
SW1(config-if)#spanning-tree bpduguard enable
SW1(config-if)#shut
SW1(config-if)#no shut
D. SW1(config-if)#interface Gi0/1
SW1(config-if)#spanning-tree bpduguard enable
SW1(config-if)#shut
SW1(config-if)#no shut
Correct Answer:
B. SW1(config-if)#interface Gi0/0
SW1(config-if)#no spanning-tree bpduguard enable
SW1(config-if)#shut
SW1(config-if)#no shut
Exam Question 66
Why is an AP joining a different WLC than the one specified through option 43?
A. The AP is joining a primed WLC
B. The APs broadcast traffic is unable to reach the WLC through Layer 2
C. The AP multicast traffic is unable to reach the WLC through Layer 3
D. The WLC is running a different software version
Correct Answer:
C. The AP multicast traffic is unable to reach the WLC through Layer 3
Exam Question 67
Company policy restricts VLAN 10 to be allowed only on SW1 and SW2. All other VLANs can be on all three switches. An administrator has noticed that VLAN 10 has propagated to SW3.
Which configuration corrects the issue?
A. SW1(config)#int gi1/1
SW1(config)#switchport trunk allowed vlan 1-9,11-4094
B. SW2(config)#int gi1/2
SW2(config)#switchport trunk allowed vlan 10
C. SW2(config)#int gi1/2
SW2(config)#switchport trunk allowed vlan 1-9,11-4094
D. SW1(config)#int gi1/1
SW1(config)#switchport trunk allowed vlan 10
Correct Answer:
C. SW2(config)#int gi1/2
SW2(config)#switchport trunk allowed vlan 1-9,11-4094
Exam Question 68
Which First Hop Redundancy Protocol should be used to meet a design requirement for more efficient default gateway bandwidth usage across multiple devices?
A. GLBP
B. LACP
C. HSRP
D. VRRP
Correct Answer:
A. GLBP
Exam Question 69
A client device roams between access points located on different floors in an atrium. The access points are joined to the same controller and configured in local mode. The access points are in different AP groups and have different IP addresses, but the client VLAN in the groups is the same.
Which type of roam occurs?
A. inter-controller
B. inter-subnet
C. intra-VLAN
D. intra-controller
Correct Answer:
D. intra-controller
Exam Question 70
Which DHCP option helps lightweight APs find the IP address of a wireless LAN controller?
A. Option 43
B. Option 60
C. Option 67
D. Option 150
Correct Answer:
A. Option 43