The latest Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 certification actual real practice exam question and answer (Q&A) dumps are available free, which are helpful for you to pass the Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 exam and earn Cisco CCNP and CCIE Enterprise Core: Implementing and Operating Cisco Enterprise Network Core Technologies (ENCOR) 350-401 certification.
Exam Question 91
Which encryption hashing algorithm does NTP use for authentication?
A. SSL
B. MD5
C. AES128
D. AES256
Correct Answer:
B. MD5
Exam Question 92
Refer to the exhibit. The trunk between Gig1/0/1 of switch SW2 and Gig1/0/1 of switch SW1 is not operational. Which action resolves this issue?
A. Configure both interfaces to nonegotiate and ensure that the switches are in different VTP domains.
B. Configure both interfaces in dynamic auto DTP mode and ensure that the switches are in the same VTP domain.
C. Configure both interfaces in dynamic auto DTP mode and ensure that the switches are in different VTP domains.
D. Configure both interfaces in dynamic desirable DTP mode and ensure that the switches are in the same VTP domain.
Correct Answer:
D. Configure both interfaces in dynamic desirable DTP mode and ensure that the switches are in the same VTP domain.
Exam Question 93
Refer to the exhibit. Which two facts does the device output confirm? (Choose two.)
A. The device’s HSRP group uses the virtual IP address 10.0.3.242.
B. The device is configured with the default HSRP priority.
C. The device sends unicast messages to its peers.
D. The standby device is configured with the default HSRP priority.
E. The device is using the default HSRP hello timer.
Correct Answer:
D. The standby device is configured with the default HSRP priority.
E. The device is using the default HSRP hello timer.
Exam Question 94
Refer to the exhibit. Which type of antenna is shown on the radiation patterns?
A. patch
B. dipole
C. omnidirectional
D. Yagi
Correct Answer:
B. dipole
Exam Question 95
A company has an existing Cisco 5520 HA cluster using SSO. An engineer deploys a new single Cisco Catalyst 9800 WLC to test new features. The engineer successfully configures a mobility tunnel between the 5520 cluster and 9800 WLC. Clients connected to the corporate WLAN roam seamlessly between access points on the 5520 and 9800 WLC. After a failure on the primary 5520 WLC, all WLAN services remain functional; however, clients cannot roam between the 5520 and 9800 controllers without dropping their connection. Which feature must be configured to remedy the issue?
A. mobility MAC on the 5520 cluster
B. mobility MAC on the 9800 WLC
C. new mobility on the 5520 cluster
D. new mobility on the 9800 WLC
Correct Answer:
B. mobility MAC on the 9800 WLC
Exam Question 96
Refer to the exhibit. Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0/24 network?
A. R2
standby 1 priority 90
standby 1 preempt
B. R2
standby 1 priority 100
standby 1 preempt
C. R1
standby 1 preempt
R2
standby 1 priority 90
D. R1
standby 1 preempt
R2
standby 1 priority 100
Correct Answer:
C. R1
standby 1 preempt
R2
standby 1 priority 90
Exam Question 97
A customer has completed the installation of a Wi-Fi 6 greenfield deployment at their new campus. They want to leverage Wi-Fi 6 enhanced speeds on the trusted employee WLAN. To configure the employee WLAN, which two Layer 2 security policies should be used? (Choose two.)
A. WPA2 (AES)
B. 802.1X
C. OPEN
D. WEP
E. WPA (AES)
Correct Answer:
A. WPA2 (AES)
B. 802.1X
Exam Question 98
Refer to the exhibit. Which action resolves the EtherChannel issue between SW2 and SW3?
A. Configure switchport mode trunk on SW2.
B. Configure switchport nonegotiate on SW3.
C. Configure channel-group 1 mode desirable on both interfaces.
D. Configure channel-group 1 mode active on both interfaces.
Correct Answer:
D. Configure channel-group 1 mode active on both interfaces.
Exam Question 99
Refer to the exhibit. A network engineer configures OSPF and reviews the router configuration. Which interface or interfaces are able to establish OSPF adjacency?
A. GigabitEthernet0/0 and GigabitEthernet0/1
B. only GigabitEthernet0/1
C. only GigabitEthernet0/0
D. GigabitEthernet0/1 and GigabitEthernet0/1.40
Correct Answer:
D. GigabitEthernet0/1 and GigabitEthernet0/1.40
Exam Question 100
Which two methods are used by an AP that is trying to discover a wireless LAN controller? (Choose two.)
A. Cisco Discovery Protocol neighbor
B. querying other APs
C. DHCP Option 43
D. broadcasting on the local subnet
E. DNS lookup CISCO-DNA-PRIMARY.localdomain
Correct Answer:
C. DHCP Option 43
D. broadcasting on the local subnet