Learn the correct command to start TCPIP in a z/OS mainframe environment. Boost your Wipro Mainframe MySkillz Trendnxt assessment score with this essential z/OS networking knowledge.
Table of Contents
Question
Which one of the following will start TCPIP
A. S TCPIP
B. P TCPIP
C. C TCPIP
D. H TCPIP
Answer
In a z/OS mainframe environment, the command to start TCPIP is:
A. S TCPIP
Explanation
This command is issued from the system console or an authorized TSO session. The S is short for START, indicating that this command starts a started task or system service. TCPIP is the name of the started task that initializes and runs the TCPIP networking stack on the mainframe system.
The other options are incorrect because:
B. P TCPIP – The P command is used to stop a started task, not start one.
C. C TCPIP – There is no C command in z/OS for starting or stopping tasks.
D. H TCPIP – The H command is used to halt a running task, not start one.
Therefore, to start TCPIP on a mainframe system, the correct and only command is S TCPIP. Knowing essential commands like this is key to successfully administering z/OS networking and acing the Wipro Mainframe MySkillz Trendnxt assessment.
Wipro Mainframe MySkillz Trendnxt certification exam assessment practice question and answer (Q&A) dump including multiple choice questions (MCQ) and objective type questions, with detail explanation and reference available free, helpful to pass the Wipro Mainframe MySkillz Trendnxt exam and earn Wipro Mainframe MySkillz Trendnxt certification.