Table of Contents
Question
A network administrator is in charge of a Mobility Master (MM) – Mobility Controller (MC) based WLAN. The administrator has deployed an Airwave Management Platform (AMP) server in order to improve the monitoring capabilities and generate reports and alerts. The administrator has configured SNMPv3 and Admin credentials on both the MMs and MCs and has created Groups and Folders in the AMP server. What two additional steps must the administrator do in order to let Airwave monitor the network devices? (Choose two.)
A. Manually add the Active MM and wait for automatic Discovery.
B. Map the AMP’s IP address with a mgmt-config profile in the MM.
C. Set the AMP’s IP address and Org string as DHCP option 43.
D. Manually add each MM, MC and Access Point in the AMP server.
E. Move “New” devices into a group and folder in Airwave.
Answer
A. Manually add the Active MM and wait for automatic Discovery.
E. Move “New” devices into a group and folder in Airwave.
Explanation
The correct answer is A and E.
A detailed comprehensive explanation is:
To let Airwave monitor the network devices, the administrator must first manually add the Active MM to the AMP server using its IP address, SNMPv3 credentials, and Admin credentials. This will allow Airwave to discover all the MCs and Access Points that are managed by the MM. The administrator does not need to manually add each MM, MC and Access Point individually, as this would be time-consuming and prone to errors.
The second step is to move the “New” devices that are discovered by Airwave into a group and folder that match their configuration and location. This will enable Airwave to apply the appropriate monitoring policies, templates, alerts, and reports to the devices. The administrator can also use labels and tags to further categorize the devices based on their attributes.
The other options are incorrect because:
B. Mapping the AMP’s IP address with a mgmt-config profile in the MM is not necessary for Airwave to monitor the network devices. This step is only required if the administrator wants to use Airwave as a configuration management tool for the MM.
C. Setting the AMP’s IP address and Org string as DHCP option 43 is not required for Airwave to monitor the network devices. This step is only useful if the administrator wants to use Zero-Touch Provisioning (ZTP) for new devices that are connected to the network.
D. Manually adding each MM, MC and Access Point in the AMP server is not an efficient or accurate way of letting Airwave monitor the network devices. This step would involve entering each device’s IP address, SNMPv3 credentials, and Admin credentials manually, which would take a lot of time and could introduce errors.
Reference
- Healthcare Management: An Introduction (AHM250) – AHIP
- Aruba AirWave Management Platform | HPE Store US
- ds_amp.pdf (securewirelessworks.com)
- Multi-vendor Network Management for Switching and Wi-Fi | Aruba (arubanetworks.com)
- Managing IAP from AirWave (arubanetworks.com)
- Appendix B: AMP CLI Options (arubanetworks.com)
- Monitoring the Network (arubanetworks.com)
- Monitoring Wired Devices (arubanetworks.com)
- Monitoring Wireless Devices (arubanetworks.com)
HP Aruba Certified Mobility Expert Written Exam HP HPE6-A79 certification exam practice question and answer (Q&A) dump with detail explanation and reference available free, helpful to pass the HP Aruba Certified Mobility Expert Written Exam HP HPE6-A79 exam and earn HP Aruba Certified Mobility Expert Written Exam HP HPE6-A79 certification.