Discover the correct VTAM command to shut down a line in an IBM mainframe environment. An expert provides a clear explanation and the exact syntax needed.
Table of Contents
Question
The command for shutting down a VTAM Line ABCD is
A. v net, id=abcd,inact
B. v net, inact,a,id=abcd
C. v net, id=abcd,scope,a
D. None of the above
Answer
The correct command for shutting down a VTAM line with the ID “ABCD” is:
A. v net, id=abcd,inact
Explanation
This command breaks down as follows:
- “v net” is the VTAM command to vary the status of a network resource
- “id=abcd” specifies the name of the line to be shut down, in this case ABCD
- “inact” sets the desired state of the line to INACTIVE, effectively shutting it down
The other options are incorrect because:
- Option B has the parameters in the wrong order
- Option C uses the SCOPE parameter which is not relevant for shutting down a line
- Option D is incorrect since the correct command is given in option A
So in summary, to properly shut down (deactivate) a VTAM line, use the command “v net,id=<linename>,inact” where <linename> is replaced with the ID of the specific line. This will immediately deactivate the line and shut down communication on it until it is re-activated.
Wipro Mainframe MySkillz Trendnxt certification exam assessment practice question and answer (Q&A) dump including multiple choice questions (MCQ) and objective type questions, with detail explanation and reference available free, helpful to pass the Wipro Mainframe MySkillz Trendnxt exam and earn Wipro Mainframe MySkillz Trendnxt certification.