Cisco Certified Network Associate (CCNA) 200-301 Exam Questions and Answers

Question 21: Refer to the exhibit. How does the router manage traffic to


A. It chooses the EIGRP route because it has the lowest administrative distance.
B. It load-balances traffic between all three routes.
C. It chooses the OSPF route because it has the longest prefix inclusive of the destination address.
D. It selects the RIP route because it has the longest prefix inclusive of the destination address.

Question 22: Refer to the exhibit. To which device does Router1 send packets that are destined to host

A. Router2
B. Router3
C. Router4
D. Router5

Question 23: Which two minimum parameters must be configured on an active interface to enable OSPFV2 to operate? (Choose two.)

A. OSPF process ID
B. OSPF MD5 authentication key
C. OSPF stub flag
D. IPv6 address
E. OSPF area

Question 24: Refer to the exhibit. What commands are needed to add a subinterface to Ethernet0/0 on R1 to allow for VLAN 20, with IP address

A. R1(config)#interface ethernet0/0
R1(config)#encapsulation dot1q 20
R1(config)#ip address
B. R1(config)#interface ethernet0/0.20
R1(config)#encapsulation dot1q 20
R1(config)#ip address
C. R1(config)#interface ethernet0/0.20
R1(config)#ip address
D. R1(config)#interface ethernet0/0
R1(config)#ip address

Question 25: Refer to the exhibit. What does router R1 use as its OSPF router-ID?


Question 26: Which function does an SNMP agent perform?

A. It sends information about MIB variables in response to requests from the NMS
B. It manages routing between Layer 3 devices in a network
C. It coordinates user authentication between a network device and a TACACS+ or RADIUS server
D. It requests information from remote network nodes about catastrophic system events

Question 27: Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two.)

A. It supports protocol discovery.
B. It guarantees the delivery of high-priority packets.
C. It can identify different flows with a high level of granularity.
D. It can mitigate congestion by preventing the queue from filling up.
E. It drops lower-priority packets before it drops higher-priority packets.

Question 28: What is the primary purpose of a First Hop Redundancy Protocol?

A. It allows directly connected neighbors to share configuration information
B. It reduces routing failures by allowing Layer 3 load balancing between OSPF neighbors that have the same link metric
C. It allows a router to use bridge priorities to create multiple loop-free paths to a single destination
D. It reduces routing failures by allowing more than one router to represent itself as the default gateway of a network

Question 29: An engineer is asked to protect unused ports that are configured in the default VLAN on a switch. Which two steps will fulfill the request? (Choose two.)

A. Configure the ports as trunk ports.
B. Enable the Cisco Discovery Protocol.
C. Configure the port type as access and place in VLAN 99.
D. Administratively shut down the ports.
E. Configure the ports in an EtherChannel.

Question 30: Which feature on the Cisco Wireless LAN Controller when enabled restricts management access from specific networks?

C. Flex ACL

Published by Thomas Apel

, a dynamic and self-motivated information technology architect, with a thorough knowledge of all facets pertaining to system and network infrastructure design, implementation and administration. I enjoy the technical writing process and answering readers' comments included.